Acu-rite Micro-Line T Uživatelský manuál Strana 34

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 46
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 33
MICRO-LINE Reference Manual
REFERENCE
31
The MICRO-LINE system is considered to be in the DRO (digital read-
out) mode when the X-axis and Z-axis positions are displayed.
DRO Mode
MICRO-LINE uses positive and negative numbers to display the position
of the tool along each axis. The graphic below shows a typical setup for
the positive and negative count directions for the X-and Z-axes on a
lathe. All of the examples in this manual are based upon this setup.
X-axis:
The axis will move away from the
center for a positive count direction.
Z-axis:
The axis will move away from the
spindle for a positive count direction.
Count Direction
Conventions
This section identifies the standard conventions that apply to your
MICRO-LINE system.
MLTmanual.QXD 2/12/02 4:10 PM Page 24
Zobrazit stránku 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 45 46

Komentáře k této Příručce

Žádné komentáře